Programming Exercises · Scenario 1
The RTU sensor inputs and relay outputs are pre-wired to the simulator. Build the control logic in between: fan enable, economizer enable, cooling stages, heating stages. Hit Run to test your sequence against a full simulated day.
Hardware
Simulation
I/O
Math
Logic
Control
Canvas
Port types
Click or drag a block from the palette to add it.
Drag from a handle to wire blocks together. Click a wire to select it, then delete it.
Right-click a block to rename it, duplicate it, hide its wires, or delete it. Select a block and press Delete or Backspace to remove it.
Select Run to start the simulation and watch values propagate. Select Hide Wires to focus on block values.
Or load a pre-built canvas from Scenarios.